Category Archives: Above Ground Pool Equipment

Looking After the Pump for Your Above Ground Pool

Ensuring that the pump for your above ground pool is working as it is supposed to is vital for every owner. The above ground pool pump is designed to circulate water around your above ground pool, helping to prevent bacteria from lingering in the water. Luckily the work needed to fix a pump error is usually minimal and can be done at home, or otherwise will cost very little to fix.

The most commonly seen issues with pump pipes are:

  • leaking joints (which will allow water to drip continuously onto the casing, thus destroying the motor)
  • burned out seals which will cause the pump to not prime correctly
  • defective bearings in the pump
  • clogged up impeller
  • lack of lubrication (on older models)—some modern pumps are usually self-oiling

Repair or Replace?

The decision to repair or replace your pool pump will depend heavily on the severity of the issue you are experiencing. Furthermore, if the pump itself seems damaged or otherwise it is not living up to your expectations, of if previous attempts to repair and error have failed repeatedly, you have to consider the possibility that the problem is not going to do the job well enough and in this case, the pump should simply be replaced outright.

Problems involving the bearings in your pump are among the simplest of the issues to fix and can often be done yourself at home. If you are not comfortable tinkering with the pump, a quick trip to the local repair store should get the pump in perfect order with just a few minutes of time and a tiny bill. However, it should be considered that problems with the bearings are often also accompanied by damage to the shaft seal and so this may be replaced at the same time.

If the impeller is blocked but is otherwise in good condition and without damage, it can be salvaged and refitted after a thorough clean out. If the blockage is so severe, however, that it has buckled the impeller or otherwise altered its shape then the impeller should be scrapped and replaced, but the rest of the pump can be kept as long as it is in good working order otherwise.

If the motor for the pool pump has already outlived its expected working life, it should be scrapped immediately and replaced entirely. An old motor will invariably need replacing at some point, so always be aware that once you are past any warranties—if applicable—then you will need to be prepared to fork out to buy a new one.

In some situations, however, the cost of trying to repair your pool pump may end up exceeding the value of the new unit entirely. Such repairs are usually numerous in natures or otherwise involve the motor in some way, and in this case, an entirely new pump is the way to go.

Conclusion

The decision on whether to replace or repair a faulty pool pump will depend largely on the severity of the damage and which parts of the pump system are in need of attention, with damage to the motor usually costing more to fix than should justifiably be spent on a repair. This being the case, an upgrade to a new pump is arguably the more cost-effective and worthwhile investment.

Read more
Apr. 27, 2019

Advantages of Having an Efficient Above Ground Pool Heater

Purchasing new equipment for above ground pool might somewhat confusing. After all, there are many things on the market to enhance your at home swimming experience. Considering swimming pool equipment can become expensive, you might be wondering if you need some of the stuff offered.

One piece of equipment every home with an above ground pool should consider is a pool heater. This fantastic piece of equipment does something no other additional piece of equipment can offer. Swimming pool heaters give the gift of enjoying a pool all year long. So even if it is reaching a cooler temp of 55, you can still get a dip in the water without frigid, icy temps getting you down.

Swimming Pool HeaterIf you are looking for the best investment in your aquatic life, purchasing an air-source heat pump might be the best choice. Air-source heat pumps can not only heat your pool in the winter but also keep the water cooler in the summer months. Think of an air-source heat pump as an all in one solution for having constant water temps all year long. These types of heaters are commonly called reverse-cycle heat pumps, meaning they can be switched from pushing more cooling air through refrigeration or provide heat with the heating elements.

Another advantage pool heater is they last a very long time. The investment in a quality pool heater such as a Hayward’s HP50HA Heat Pump can continue a decade, ensuring you get the most out of your above ground pool. In addition to their excellent lifespan, the cost of operation is considerably lower than other options. Most heat pumps are energy efficient and won’t increase your energy bill drastically.

Lastly, an above ground pool heater is reliable. Of all the equipment options you can purchase to enhance your backyard aquatic fun spot, heaters won’t stop working and maintain a consistent temperature. As long as the heater is managed correctly and the installation was done correctly, there isn’t much that needs to be done other than enjoying the new found comforts. There is no need for a hot tub in the winter, if your pool is equipped with a pool heater, and you will notice your pool getting used more.

With all these advantages a homeowner can indulge in with the purchase of an above ground pool heater, it’s easy to say, it is worth the buy. Above Ground Pools offers a terrific option for maintaining pool temps year round with the Hayward HP50HA Heat Pump.

Read more
Jan. 23, 2018

How to Choose the Best Above Ground Pool Filtration System

The filter of your above ground pool is charged with a hefty task of removing debris and particles from your pool. A swimming pool filter is an important aspect that does require some thought. Many aren’t aware that there are different types of filters or even if some are better than the others. Each has their own set of benefits. One thing is for sure, pool filters are a necessary part of maintaining a healthy good looking pool.

Sand Filters
Sand Filters
Sand filters have been the oldest form of pool filtration used in above ground pools. One of the reasons pool owners love sand filter system kits is because of cost and reliability. Sand filters are the cheapest option for maintaining a cleaner pool. How sand filters work is also quite simple. Pool water will enter the filter trap and it will wash over the sand. The sand will then absorb debris and oils, and water will return to the pool. There aren’t many negatives associated with this option, other than overtime sand can start to seep out. The sand filters design is also more complicated than the cartridge option. It is time to replace the sand filter when sand particles begin to venture into your pool.

Cartridge Filters

If you are looking for a pool filter that is easy to install and that does maximum amounts of debris of your pool, then a cartridge filter will be for you. These are a little more expensive than sand filters, but do an excellent job removing insects, algae, and dirt from the pool. As with the sand filters, cartridge filters will allow water in and remove anything that isn’t clean healthy water, and let it flow back. The most prominent disadvantage pool owners find when using a cartridge filter is they need to be cleaned every week or two to maintain optimal performance.
Filtration Systems
These filters are also the best choice for smaller pools. If you need a complete setup or just a screen, Pools Above Ground offers both filter systems and kits. The pool filter system kits are complete with everything you need to get started including:

    Pump
    Filter Body Mounting
    Platform Base
    Hoses, Clamps, and Fittings

What if I Own a Saltwater Above Ground Pool?

Saltwater pool systems are a little more complicated than the standard pools but also offer many benefits that regular above ground pools do not. For instance, their maintenance cost is less expensive after the initial purchase. The typical sand and cartridge type filters aren’t designed for saltwater pools; they use their saltwater filtration system. Since water is pumped through an electrolytic cell for filtration, it works differently than sand or cartridge filters. Salt mixes with an electrode charge to produce the best quality chlorine. Replacements for this part is expensive, but they can last 3 to 5 years without problems.

Read more
Jan. 19, 2018